Watchdog Timer Interfaces For The Linux Operating System Alan Cox Custom Linux Driver And Program Development The following watchdog drivers are currently implemented: ICS WDT501-P ICS WDT501-P (no fan tachometer) ICS WDT500-P Software Only Berkshire Products PC Watchdog Revision A & C (by Ken Hollis) All six interfaces provide /dev/watchdog, which when open must be written to within a timeout or the machine will reboot. Each write delays the reboot time another timeout. In the case of the software watchdog the ability to reboot will depend on the state of the machines and interrupts. The hardware boards physically pull the machine down off their own onboard timers and will reboot from almost anything. A second temperature monitoring interface is available on the WDT501P cards and some Berkshire cards. This provides /dev/temperature. This is the machine internal temperature in degrees Fahrenheit. Each read returns a single byte giving the temperature. The third interface logs kernel messages on additional alert events. Both software and hardware watchdog drivers are available in the standard kernel. If you are using the software watchdog, you probably also want to use "panic=60" as a boot argument as well. The wdt card cannot be safely probed for. Instead you need to pass wdt=ioaddr,irq as a boot parameter - eg "wdt=0x240,11". The i810 TCO watchdog modules can be configured with the "i810_margin" commandline argument which specifies the counter initial value. The counter is decremented every 0.6 seconds and default to 50 (30 seconds). Values can range between 3 and 63. The i810 TCO watchdog driver also implements the WDIOC_GETSTATUS and WDIOC_GETBOOTSTATUS ioctl()s. WDIOC_GETSTATUS returns the actual counter value and WDIOC_GETBOOTSTATUS returns the value of TCO2 Status Register (see Intel's documentation for the 82801AA and 82801AB datasheet). Features -------- WDT501P WDT500P Software Berkshire i810 TCO Reboot Timer X X X X X External Reboot X X o o o I/O Port Monitor o o o X o Temperature X o o X o Fan Speed X o o o o Power Under X o o o o Power Over X o o o o Overheat X o o o o The external event interfaces on the WDT boards are not currently supported. Minor numbers are however allocated for it. Example Watchdog Driver ----------------------- #include #include #include int main(int argc, const char *argv[]) { int fd=open("/dev/watchdog",O_WRONLY); if(fd==-1) { perror("watchdog"); exit(1); } while(1) { write(fd,"\0",1); fsync(fd); sleep(10); } } Contact Information People keep asking about the WDT watchdog timer hardware: The phone contacts for Industrial Computer Source are: Industrial Computer Source http://www.indcompsrc.com ICS Advent, San Diego 6260 Sequence Dr. San Diego, CA 92121-4371 Phone (858) 677-0877 FAX: (858) 677-0895 > ICS Advent Europe, UK Oving Road Chichester, West Sussex, PO19 4ET, UK Phone: 00.44.1243.533900 and please mention Linux when enquiring. For full information about the PCWD cards see the pcwd-watchdog.txt document.